巴黎人票APP

    1. <form id='Jzaafw'></form>
        <bdo id='Jzaafw'><sup id='Jzaafw'><div id='Jzaafw'><bdo id='Jzaafw'></bdo></div></sup></bdo>

            暖通空调杂志社>期刊目次>2018年>第1期

            不同热泵工质低温制热性能的比较

            Heating performance comparison of different heat pump refrigerants at low temperature

            丁若晨 许树学 黄成达 马国远 党超镔
            北京工业大学

            摘要:

            基于某品牌的涡旋压缩机搭建了实验装置。在蒸发温度为-25~0 ℃、冷凝温度为45 ℃的工况下,分别测试了R22,R134a,R410A,R1234ze,R1234yf在单级系统和补气系统中的性能。结果发现:R410A的制热量最大,R1234yf的排气温度最低,R1234ze的制热COP最大;相比单级系统,虽然补气系统压缩机功率略有增大,但可明显降低压缩机排气温度、提高制热量,制热COP最大提升29.3%。

            关键词:热泵,工质,低温,单级系统,补气系统,实验研究

            Abstract:

            Sets up an experimental device for a scroll compressor. Under the condition of evaporating temperature from -25 to 0 and condensing temperature of 45 , tests the performance of R22, R134a, R410A, R1234ze and R1234yf in single stage compression system and the vapor injection system respectively. The results show that R410A has the largest heating capacity, R1234yf has the lowest discharge temperature and R1234ze has the highest heating COP. Compared with the single stage compression system, though the compressor power of the vapor injection system increases slightly, it can significantly reduce the discharge temperature, increase the heating capacity and the maximum increase of heating COP is 29.3%.

            Keywords:heatpump,refrigerant,lowtemperature,singlestagesystem,vaporinjectionsystem,experimentalresearch

                你还没注册?或者没有登录?这篇期刊要求至少是本站的注册会员才能阅读!

                如果你还没注册,请赶紧点此注册吧!

                如果你已经注册但还没登录,请赶紧点此登录吧!